Philips IntelliVue MX800 - Starting the Different Types of Report

26 Printing Patient Reports
324
Starting the Different Types of Report
Stopping Reports Printouts
• To stop Reports printing, in the Reports menu, select
Report types Report contents How to start printing reports
Vital Signs Report depends on selected trend group, data
resolution, and period.
In the Vital Signs window, select Print/ Record, then select
Print.
Graphic Trends Report In the Graphical Trends window, select Print.
Events Reports Event Episode In the Event Episode or Event Review window, select the pop-
up key Print/ Record, then select Print Review or Print
Episode.
Graphic or tabular Event Review
EEG Report EEG Waves, numerics, CSAs, montage
information and impedance values
In the Setup EEG menu, select Print Report.
ECG Reports Depends on format selected Select the ECG Report A or ECG Report B Smartkeys, if
configured, or the Print Reports SmartKey followed by ECG
Report A or ECG Report B.
ST Map Report ST data in a transversal and/or
horizontal multiaxis diagram,
In the ST Map (Current) or ST Map (Trend) window, select
Print.
Cardiac Output Report Trial curves and numerics In the Cardiac Output (Right Heart) or Cardiac Output
(Transpulmonary) window, select the pop-up key Print/
Record.
Wedge Report Wedge numerics and reference wave In the Wedge window, select the Print Wedge pop-up key.
Calculations Report Hemodynamic, Oxygenation, or
Ventilation Review
In the Calculations windows, select the Print/ Record pop-up
key.
Drug Calculator
Report
Titration Table In the Titration Table window, select the Print Titr.Tbl pop-up
key.
Drip Table In the Drip Table window, select the Print Drip Tbl pop-up key.
Alarm Limits Report Graphic and numeric report of all
current alarm limits
In the Alarm Limits window, select Print Limits.
Realtime Reports,
including oxyCRG
Re
ports
patient data and numerics, and either:
all displayed waves OR all measured
waves OR all measured RT waves Or all
measured HiRes waves, OR oxyCRG
waves (RT waves: ECG Primary lead,
Pleth, Resp; HiRes waves: btbHR, HiRes
SpO
2
, HiRes Resp)
Select the Realtime Report SmartKey, if configured.
Loops Report Individual Loops diagram with
timestamp, currently measured numerics
In the Loops window, select Print Loop.
Battery Report Battery serial numbers, information on
the currently-measured and potential
charge status of the battery or batteries
In the Battery Status window, select Print Status.
Central Report A/B/C These are reports configured at the
Information Center. Monitors connected
via the IntelliVue Instrument Telemetry
wireless network can have these reports
available.
In the Main Setup select Reports then Central Report A,
Central Report B or Central Report C.