29 VueLink Modules
349
Viewing the VueLink Device Data Window
To view the VueLink device data window, either
• select the setup hardkey on the VueLink module or the
External Devices SmartKey, and then
select the pop-up key for the device, or
•in the
Setup <External Device> menu, select Show Device Data.
Select the device data window then the
Setup Device key to open the setup menu for the connected
device.
Using VueLink Screens
Your monitor may be configured to show VueLink device data permanently on the Screens.
Select the device data window to display the external device pop-up keys that let you access the setup
menu and carry out external device tasks.
Switching VueLink On and Off
• To switch VueLink measurements on and off, in the setup menu for the external device, select
Device Interface to toggle between the settings On and Off.
Alarms/INOPs From External Devices
The VueLink module itself generates INOPs, but does not generate alarms. If the external device's
alarms are on, the module transmits these to the monitor. A message in the VueLink info window tells
you either
Device Alarms Ignored or Device Alarms Accepted or No Alarms Available. External
device alarms status symbols precede some, but not all, measurement labels.
the monitor is configured to accept external
device alarms, but the alarms are switched off at
the external device.
! alarms status of this external measurement is
unknown
To Next Page
Loading...