Philips IntelliVue MX800 - Performing Calculations for a Non-Specific Drug; 1 Enter three of these four values: dose, amount, volume, and rate of the infusion solution.; 2 If you have chosen a weight-dependent dose unit, you must enter the patient weight now or choose a different unit.; 3 When you have entered three values, the Drug Calculator automatically calculates the unknown fourth value and shows it in the highlighted field. Standardized rate and concentration are also calculated.

27 Using the Drug Calculator
339
Performing Calculations for a Non-Specific Drug
If a list of drugs has not been configured for your monitor, you can use the Drug Calculator to
calculate drug doses for a single, generic drug called
ANY DRUG. Selecting the arrow beside the drug
name in the
Drug Calculator window shows that are no other drugs configured.
1 Enter three of these four values: dose, amount, volume, and rate of the infusion solution.
To enter values, select the correct unit, then select each value field and use the pop-up keypad to
enter the correct value.
2 If you have chosen a weight-dependent dose unit, you must enter the patient weight now or
choose a different unit.
If available, the patient weight from the
Patient Demographics window is entered automatically in
the
Drug Calculator window when the Drug Calculator is accessed. To change the patient weight,
select the
Weight key then use the on-screen keypad to enter the correct value. This will not
change the patient weight stored in the patient demographic information.
3 When you have entered three values, the Drug Calculator automatically calculates the unknown
fourth value and shows it in the highlighted field. Standardized rate and concentration are also
calculated.
Performing Calculations for a Specific Drug
1 Select the arrow beside ANY DRUG, then select the required drug from the list of drugs.
This opens the window for the selected drug.