28 IntelliBridge EC10 Module
344
Changing Waves and Numerics Displayed
To change the waves and numerics from the IntelliBridge module displayed on the Screen,
1 Select Main Setup, Measurements, then <External Device> to enter the setup menu for the
connected device.
2 Select Setup Driver.
3 Select Setup Wavesor Setup Numerics and make the changes required.
4 Close the setup menu. The monitor takes a few seconds to activate the change.
Viewing the IntelliBridge Device Data Window
To view the IntelliBridge device data window, either
• select the setup key on the IntelliBridge module, or
• select the
External Devices SmartKey and then select the pop-up key with the device name on it,
or
•in the
Setup <External Device> menu, select Show Device Data.
Check that the correct external device ID is shown in the window title.
Select the device data window then
Setup Device to open the setup menu for the connected device.
With the
More Data key you can page through additional data which does not fit on the first screen.
When an infusion system is connected the data is presented differently. The data from each pump is
displayed in a horizontal frame in the window. Data from several infusion pumps can be displayed.
To see a detailed information window for one of the pumps, you can select data for that pump on the
Screen or select the
More Data pop-up key.
Using Screens with External Device Data
Your monitor may be configured to show external device data permanently on the Screens.
Select the device data window to display the pop-up keys that let you access the setup menu and make
changes.
To Next Page
Loading...