29 VueLink Modules
348
The device labels (2) on the module indicate for which external devices the module is configured. The
selection LED (3) shows which device is currently active. The device label text may differ slightly from
the labels on the external devices.
See the documentation supplied with the VueLink module for a list of supported devices and
accessories, and for configuration information.
Connecting an External Device
1 Insert the module into the FMS or integrated module slot.
2 Check that the device selection LED (3) lights to show that it has correctly identified the external
device. If not, select
Main Setup, Measurements and then the name of the external device to
enter the setup menu for the connected device.
3 In the device setup menu, select Device, select the correct device from the list, and confirm the
selection.
4 Connect the external device to the module and switch it on.
Once the VueLink device has been correctly connected, you can select the
External Devices
SmartKey and then select the
Setup Device pop-up key to access the setup menu for the connected
device.
CAUTION
Selecting the wrong device can cause unpredictable system behavior. Rectify this by switching off the
external device when it is safe to do so, and selecting the correct device.
Changing VueLink Waves and Numerics Displayed
To change the waves and numerics from the VueLink module displayed on the Screen,
1 Select Main Setup, Measurements and then the name of the connected device to enter its setup
menu.
2 Select the item you want to change, then select the new item from the pop-up list,
or
Select
Show Device Data to view the device data window.
3 Close the setup menu. The monitor takes a few seconds to activate the change.
To Next Page
Loading...