7
Setting up Spirometry 228
15 Monitoring tcGas 231
Identifying tcGas Module Components 231
Setting the tcGas Sensor Temperature 231
Using the tcGas Site Timer 232
Setting the tcGas Barometric Pressure 233
Remembraning the tcGas Transducer 233
Calibrating the tcGas Transducer 233
Applying the tcGas Transducer 235
Finishing tcGas Monitoring 236
TcGas Corrections 236
16 Monitoring Intravascular Oxygen Saturation 239
Selecting a Measurement Label 240
Preparing to Monitor with the M1021A Wide Module 240
Preparing to Monitor with the M1011A Narrow Module 244
Further Information for Both Modules 245
17 Monitoring EEG 247
EEG Monitoring Setup 247
Using the EEG Impedance/Montage Window 248
About Compressed Spectral Arrays (CSA) 250
Changing EEG Settings 251
EEG Reports 252
EEG Safety Information 253
EEG and Electrical Interference 253
18 Monitoring BIS 255
BIS Monitoring Setup 255
BIS Continuous Impedance Check 258
BIS Cyclic Impedance Check 258
BIS Window 259
Changing the BIS Smoothing Rate 260
Switching BIS and Individual Numerics On and Off 260
Changing the Scale of the EEG Wave 260
Switching BIS Filters On or Off 260
BIS Safety Information 261
19 Assigning a Telemetry Device and a Monitor to One Patient 263
How Can You Combine Devices? 263
Functions Available When the Telemetry Data Window is Displayed 265
General Telemetry-related Functions 266
Use Models With Telemetry 268
To Next Page
Loading...