Philips ST80i - Page 115

Printing During the Stress Test
ST80i Stress Test System Instructions for Use 3-43
– Local Thermal Printer
 Select Rhythm Report Printer:
–Off
– Local Thermal Printer
 Select Final Report Printer:
–Off
– PDF Complete
– Microsoft XPS Document Writer
– Local Thermal Printer
On the Config screen [User Profile  ECG Report], ECG Print is preconfigured with the
following:
 ECG Layout
 Speed (mm/sec)
 Gain (Limb Leads)
 Scale (Chest Leads)
On the Config screen, the timing of the ECG Print is configured on the
Exercise Protocols tab.
The print interval options include:
 Off
 Begin
 End
 EveryLeads
You can also print an ECG at any time by clicking the
12 Leads Print button.
On the Config screen [User Profile  Rhythm Report], you can configure Rhythm Print
settings for the Rhythm Report. They include:
 ECG Layout - select Leads
 Rhythm Settings
– Speed mm/sec - 5, 10, 25, 50
– Gain (Limb Leads) - 2.5, 5, 10, 20
– Scale (Chest Leads) - Full, Half
During the patient session, you can change the Rhythm Print settings using the
Gear (Quick
Settings)
icon. See “Using the Toolbar Icons” on page 2-15 for an explanation.