Maintaining the ST80i Thermal Printer
ST80i Stress Test System Instructions for Use 5-3
Maintaining the ST80i Thermal Printer
You should implement a satisfactory cleaning and inspection schedule for this equipment for
proper equipment operation and to reduce the possibility of equipment failure.
NOTE There are no serviceable parts for this printer. Should you experience problems with the printer, it is
replaced as a whole.
Inspecting the ST80i Thermal Printer
Inspect the equipment for the following conditions on a regular basis:
Examine power cable and the network cable for obvious damage (for example, torn
insulation, broken connectors, and so on). Replace cables as necessary.
All cords and connectors are securely seated in their corresponding connections.
Examine the equipment for missing screws, cracks or broken areas that might allow
unintended access to internal electronics areas
Cleaning the ST80i Thermal Printer
NOTE If the system is configured with a laser printer, refer to the User Guide provided
with the printer for maintenance and cleaning instructions.
To clean the printer
1
Disconnect the power source.
2 Clean the exterior surface of the unit with a damp cloth using a solution of mild
dishwashing detergent diluted in water.
3 After washing, thoroughly dry off the unit with a clean, soft cloth or paper towel.
Clean the print head monthly, as described next.
To clean the print head
NOTE Do not let soap or water come into contact with the writer, plugs, jacks or vents.
1
Open the writer door.
2 Lightly rub the print head with an alcohol pad.
3 Wipe with a clean cloth to remove alcohol residue.
4 Allow the print head to air dry.
5 Clean the platen by using adhesive tape. Apply the tape and pull it off. Rotate roller and
repeat until entire roller is clean.
6 Clean the paper sensor.
To Next Page
Loading...
