Specifications
ST80i Stress Test System Instructions for Use E-3
Specifications
ST80i System Specifications
CAUTION The system does not contain user-serviceable parts. Any modification of this device may alter
defibrillator protection. Only qualified service personnel are authorized to modify any part of this
device.
Table E-2 ST80i system specifications
Function Specifications
Instrument type
Exercise stress test system
Isolation transformer power
Rated Input/Output Voltage:
120 VAC @ 50/60 Hz
Rated Input/Output Voltage: 240 VAC @ 50/60 Hz
Input Channels
Simultaneous acquisition of all 12 leads
Standard leads
I, II, III, aVR, aVL, aVF, V1, V2, V3, V4, V5, V6
Exercise equipment
interface
Digital serial interface to treadmill or ergometer
Automatic blood pressure
measurement option
Supports optional SpO2 and motion tolerant NIBP
modules.
Network option
Optional Network interface for data transfer and printing
across your local network
Remote Review Workstation
option
Optional Remote Review Workstation for review, printing,
and editing of patient text data acquired from the ST80i
system.
Display format Sweep speed. Two supported speeds: 25 mm/s and 50 mm/s
Size Range from 19" to 24"
Resolution. The lowest resolution for each layout:
For 4:3, the lowest resolution is 1024x768
For 16:9, the lowest resolution is 1280x720
ECG input
Simultaneous input from all 12 leads
Input impedance
Meets the requirements of ANSI/AAMI EC-11
Defibrillator protected when used with specified
patient cable
Input dynamic range
Meets the requirements of ANSI/AAMI EC-11
To Next Page
Loading...
