Working with Reports
4-10 ST80i Stress Test System Instructions for Use
For more information regarding patient fields, see the section entitled “Patient Information
Management” on page 3-5.
When you click the
Confirm button, a dialog box is displayed.
Figure 4-3
To confirm the report
1
Enter your User ID.
2 Enter your password.
3 Click OK.
Replay
When you click the Replay button on the Report screen, you can review the real-time ECG
waveforms. This button provides you with the ability to review a back-completed stress report
that is either finalized or non-finalized.
You can also print a 12-Lead ECG or print a rhythm strip during the review of the study. This
feature is beneficial if you wish to review a specific segment of the test. When reviewing a
test, you can:
Change the ECG waveform speed from real-time speed to four times faster or slower
Pause the ECG stream
Print or reprint a 12-lead ECG or rhythm strip for significant episodes
Move the trend cursor to any location to skip forward or back in time
To replay the exercise stress test
1 Click the Replay button on the Procedure bar.
This brings you to ECG results that were recorded at the start of the Exercise phase. You
can then view the exercise stress test by using the “floating status bar” that appears at the
bottom of the ECG. This bar may be hidden.
2 To view the bar, sweep your pointer over image.
A gray circle moves across the status bar (blue). As it moves, the time is displayed to the
right showing both current and end time.
To Next Page
Loading...
