Philips ST80i - Final Stress Report Overview

Final Stress Report Overview
ST80i Stress Test System Instructions for Use 4-13
Final Stress Report Overview
The Final Stress Report is based on data gathering during the 5 phases of an exercise stress
test. They include:
 Pre Exercise Phase
 Exercise Phase
 Recovery (and Post-Recovery) Phase
 Report Phase
The Final Stress Report includes the patient information summary, trends, average QRS,
resting ECG results and events. ST80i allows you to choose several individual reports to
include in the Final Stress Report.
The composition of a stress report may or may not include the following:
 Patient ID Report
 Summary Report
 Trends Report
 Average QRS Report
 12-Lead ECG Report
 Rhythm Events Report
 ST Analysis
 Interpretation
 Measurements
After finishing the data acquisition, stress testing enters the report-generating phase. Once
signed by a cardiologist or clinician, the report is finalized.
After a stress test procedure, you work from the Report screen to review, update, and save the
data for the Final Stress Report. When the report is satisfactory, you can print the individual
reports on a laser printer or directly to a thermal printer when printing from ST80i.
Data from the Recovery phase is included as part of the final report. In the Post-Recovery
phase, the data will not be saved unless an event is triggered. If so, only the event data is saved
as part of the final report.
WARNING ECG signals printed on a laser report should not be used to make time-sensitive measurements
directly from the printed page.
NOTE The Final Stress Report cannot be saved without patient demographics.