Philips ST80i - High Ramp Protocol

Protocol Reference
B-10 ST80i Stress Test System Instructions for Use
High Ramp Protocol
The Pre-Exercise phase settings are the same as for the Bruce protocol. See Figure X-1 on
page X. The Recovery phase settings are the same as for the Medium Ramp protocol. See
Figure X-8 on page Y.
Table B-10 High Ramp Protocol Settings
High Ramp
Stage # Time
Duration
(mm:ss)
Speed
(mph)
Grade
(%)
ECG Print BP
Measurement
Pre-Exercise
1 Unlimited 1.0 0.0 Of
f
Off
Exercise
1 0:30 1.6 5.0 End End
2 0:30 1.7 10.0 End End
3 0:30 1.7 10.0 End End
4 0:30 2.0 10.0 End End
5 1.00 2.2 11.0 End End
6 0:30 2.4 11.5 End End
7 0:30 2.5 12.0 End End
8 0:30 2.6 12.5 End End
9 0:30 2.8 13.0 End End
10 1.00 3.0 13.5 End End
11 0:30 3.2 14.0 End End
12 0:30 3.4 14.0 End End
13 0:30 3.5 14.5 End End
14 0:30 3.6 15.0 End End
15 1.00 3.7 15.5 End End
16 0:40 4.0 16.0 End End
17 0:40 4.2 16.0 End End
18 0:40 4.4 16.5 End End
19 0:40 4.6 17.0 End End
20 0:40 4.8 17.5 End End
21 0:40 5.0 18.0 End End
22 0:40 5.2 19.0 End End
23 0:40 5.5 20.0 End End
24 0:40 5.8 21.0 End End
25 0:40 6.0 22.0 End End
Recovery
1 3:00 1.0 0.0 Every
02:00
Every 02:00