Configuring and Using the Printer
C-6 ST80i Stress Test System Instructions for Use
3 Place the pack of thermal paper into the paper tray such that the grid side of the paper is up
when it is pulled over the paper tray cover.
The paper cue mark (a small black rectangle) should be in the lower left corner.
4 Manually advance one page of paper beyond the closure point of the writer.
Make sure the paper lays on the black roller evenly within the channel of the paper door.
5 Slide the writer cover to the right until the cover latches in a locked position.
You will hear a sharp click when the door is properly latched.
6 Push the form-feed button to align the cue mark and prepare the paper for printing.
Setting Up the Thermal Printer
To connect the ST80i thermal printer
1
Connect the AC power cord to the AC connector (B) on the printer and to an AC power
outlet.
2 Connect one end of the crossover network cable to the network connector (D) on the
ST80i thermal printer and the other end to the PCI card connector on the back of the ST80i
PC, as shown in Figure C-3, below.
A Serial connector. Not used. B AC connector (for power cord)
C AC fuses D Integrated network (LAN) connector
To Next Page
Loading...
