Philips ST80i - Electromagnetic Compatibility (EMC)

Supported Treadmills and Ergometers
ST80i Stress Test System Instructions for Use E-7
Supported Treadmills and Ergometers
The ST80i Stress Test System supports the following treadmills and ergometers.
Electromagnetic Compatibility (EMC)
Electromagnetic compatibility with surrounding devices should be assessed when using the
ST80i Stress Test System and optional Thermal Printer.
An electronic device can either generate or receive electromagnetic interference. Testing for
electromagnetic compatibility (EMC) has been performed on the ST80i Stress Test System
and optional Thermal Printer according to the international standard for EMC for medical
devices (IEC 60601-1-2 Edition 2). This IEC standard has been adopted in Europe as the
European Norm (EN 60601-1-2 Edition 2).
The ST80i Stress Test System and optional Thermal Printer should not be used adjacent to, or
stacked on top of, other equipment. If the ST80i Stress Exercise Testing System and optional
Thermal Printer must be used adjacent to or stacked on top of other equipment, verify that the
Table E-5 Supported Treadmills and Ergometers
Equipment Manufacturer Models
Treadmills
Trackmaster Treadmills
by Full Vision
 FVX328
 FVX328C
 FVX328CP
 TMX425
 TMX425C
 TMX425CP
Ergometers
Ergoline  Ergometer Type er800S
 Ergometer Type er900
 Ergometer Type er900EL
 Ergoselect Reha
 Ergoselect 600
(recumbentbike, ergometer)
Lode
 Angio
 Corival
 Excalibur Sport