Philips ST80i - Printing Reports; Printer Configuration

Printing Reports
ST80i Stress Test System Instructions for Use 4-25
Printing Reports
On the Report screen, there are three options for printing reports:
 Print (Quick Print Settings) button - on the Procedure bar
 Print button on the Resting ECG tab and Event tab.
 Post Recovery ECG (two print buttons below Change Lead at bottom of screen)
The printers, for printing individual reports or the Final Stress Report, are preconfigured in the
Settings section of the application. However, the printer default settings and the “Print Grid”
on/off setting (if you are using a laser printer) can be changed on the Report screen.
You can also preconfigure the print settings to add your facility logo and site information to
the Final Stress Report. See the ST80i Installation and Configuration Guide for how to add
your facility logo.
The four main reports that comprise the Final Stress Report are preconfigured with specific
settings as part of the user profile. This is also done in the Settings section of the application.
 ECG Report
 Event Report
 Rhythm Report
 Final Report
Printer Configuration
ST80i supports the following printer options:
 Thermal printer - you can only print on the device. The optional thermal printer supports
all printing formats, including resting ECG auto/rhythm printing, and stress ECG report
printing.
 Laser printer - you can print locally on the device where a laser printer is attached or
through the network to a remote laser printer. The laser printer supports all formats except
for the continuous/real-time printing.
 Remote printers - if ST80i is set up to connect remotely to a default laser printer, this
printer path needs to be setup first. The remote printers support all formats except for the
continuous/real-time printing.
The default printer is configurable in the Settings section of the application. However, you can
manually change the settings on the Report screen using the
Print (Quick Print Settings)
button.
You can print on either the thermal printer or a laser printer using standard paper. If you print
to a laser printer, you can preconfigure the grid to print on standard paper. This setting option
for each report is in the user profile (Settings  User Profile  ECG Report, Events Report,