The Patient Session
3-14 ST80i Stress Test System Instructions for Use
When using the wireless PIM, refer to the ST80i Wireless Patient Interface Module
Instructions for Use for details on its preparation, configuration, and use.
If your facility is using more than one PIM, each one must be added to the ST80i application
under Settings (System Settings; I/O Devices). When you connect the patient to one of the
PIM devices, you also need to verify the address on the device with the address that shows up
on the Pre Exercise screen.
To preconfigure multiple PIM addresses, see the ST80i Installation and Configuration Guide.
Checking the Treadmill/Ergometer Connection
During the entire stress test, the host-side application validates the response from treadmill/
ergometer to ensure the communication between PC and treadmill/ergometer is successful.
To Next Page
Loading...
