Philips ST80i - Display

Using the Toolbar Icons
ST80i Stress Test System Instructions for Use 2-31
 AC Filter: 50Hz, 60Hz, None
 Artifact Filter: On, Off
 Smart Filter: On, Off
The same filter settings apply to both displayed and printed waveforms. The filter settings are
printed with the report.
To change the Filter settings
1
Select the Gear (Quick Settings) icon.
2 Select the Filter tab.
3 Change or modify each filter, as required.
4 Click OK to save changes.
For more information, see “Filtering” on page 3-25.
Display
On the Display tab, you can change the Limb Gain, Chest Gain, and Speed.
To change the Display settings
1
Click the Gear (Quick Settings) icon.
2 Select the Display tab.
3 Use the drop-down arrow to adjust the Limb Gain setting.
4 Change the Chest Gain setting:
–Full
–Half
5 Change the speed:
–25 mm/s
–50 mm/s
6 Click OK to save your settings.