Maintaining the ST80i System
5-6 ST80i Stress Test System Instructions for Use
Cleaning the Equipment
The wireless patient module (PIM), PIM holder, and lead wires must be cleaned after each use.
To clean the PIM, PIM holder, USB interface, and lead wires
1
Dampen a soft cloth with one of the disinfectants or cleaning agents listed below.
Clean the lead wires with any of the following:
– Cidex Ortho Phthaladehyde
– Cetylcide
– Vesphene 2 Aqueous Phenolic Germicidal Agent
CAUTION Do not:
Use isopropyl alcohol
Autoclave the patient module, patient cable/lead wires, or use ultrasonic cleaners
Immerse
Use abrasive materials
Wet the connectors
2 Wring excess moisture from the cloth before cleaning.
3 Simply wipe off the exterior of the PIM, PIM holder, and the USB interface connector.
To Next Page
Loading...
