E
E-1
Appendix ASpecifications and Requirements
For details about setting up the system, see the ST80i Installation and Configuration Guide.
NOTE No user serviceable parts are inside. ANY modification of this device may alter defibrillator
protection. Any modification to any part of this device is to be performed only by qualified service
personnel. See also Chapter 5, “Maintaining the ST80i System”
This appendix provides the following information:
ST80i System Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-1
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-4
ST80i System Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-4
Medical Isolation Transformer Specifications . . . . . . . . . . . . . . . . . . . . . .E-6
ST80i Thermal Printer Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-7
Supported Treadmills and Ergometers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-8
Electromagnetic Compatibility (EMC) - To be finalized . . . . . . . . . . . . . . . . .E-8
Accessories and Cables Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-9
Guidance and Manufacturer’s Declaration: Electromagnetic Emissions.E-10
Guidance and Manufacturer’s Declaration: Electromagnetic Immunity .E-11
Recommended Separation Distances . . . . . . . . . . . . . . . . . . . . . . . . . . . .E-15
ST80i System Requirements
For the ST80i System to function properly, the following minimum specified system
requirements must be met.
TIP For the latest information on supported systems and requirements, visit the Philips website listed
below and select the Cardiology product line. The ST80i documentation and Technical Data Sheet
containing the latest specifications are available online.
www.medical.philips.com/goto/productdocumentation
To Next Page
Loading...
