Working with Reports
4-16 ST80i Stress Test System Instructions for Use
On this screen, the gender specific parameters, measurements and risk scores that are
displayed can be printed. In addition, you can override the algorithm and select Max ST
deviation for the risk-score calculation. When you change the parameters, they appear in dark
red and italic.
NOTE The Summary Report cannot be printed without patient demographics.
On the Summary tab of the Report screen, you can include your comments about the test, along
with the Reason to End and Symptoms. All values included are based on data captured during
each stage of the exercise stress test. The screen is divided into four sections:
Summary – The Summary region shows total exercise time, maximum treadmill speed,
and maximum grade or watts (for Ergometers), as well as leads displaying greater than
100 microvolts of ST change. Duke and FAI score also appear, if applicable. FAI %
statistics only appears for the Bruce protocol.
Max Values – Max values are presented as HR and time-achieved percentage of target HR
achieved, and maximum METS obtained as well as Double Product and maximum
systolic BP/maximum diastolic BP.
Max ST – Maximum ST measurements, based on J+60ms, are presented with elevation,
depression, total change, and ST/HR Index.
Comments – In the Comments section, you can:
– Update the Comment fields:
– Narrative
– Technician
– Reviewing Physician
– Reason for End – Update the Reason for End using the up and down arrows, as
well as the
Del and Add buttons.
The ComboBoxItem 1 below Reason for End is used for X.
– Symptoms – Update the Symptoms using the up and down arrows, as well as the
Del and Add buttons.
The ComboBoxItem 1 below Symptoms is used for Y.
The Summary Report includes the following information on page 1:
Summary data displayed on the Report screen:
– Total exercise time
– Maximum treadmill (or ergometer) speed and grade achieved during test
– Max grade
– ECG leads that presented more than 100 uV (or 1 mm) of ST elevation or depression
during test
– Functional Aerobic Impairment (FAI%). Only for Bruce protocol
–PVCs
To Next Page
Loading...
