Using the Toolbar Icons
ST80i Stress Test System Instructions for Use 2-33
To change Sync Out settings
1
Select the Gear (Quick Settings) icon.
2 Select the Sync Out tab.
3 Use the drop-down menu to modify the following:
– Analog Out 1 Amplify Ratio [drop-down]
– [Example: Analog Out: I; Amplify Ratio: 3 mV/V]
– Options: None; Leads I - V6
– Analog Out 2 Amplify Ratio [drop-down]
– [Example: Analog Out 2: None; Amplify Ratio: 1 mV/V
– Options: None; Leads I - V6
– TTL Out Polarity/Duration (ms) [drop-down]
– [Example: TTL Out: None; Polarity: Positive; Duration: 50 ms]
– Options: None; Leads I - V6
– Polarity (Positive/Negative)
– Duration: default is 100 ms.
4 Click OK.
To Next Page
Loading...
