User’s Manual of WGSD-10020 Series
class3 level on the 802.3at mode will be reserved the same PoE power with
802.3af mode.
• Priority
The Priority represents PoE
ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in the case when total power consumption has been over
total power budget. In this case the port with the lowest priority will be turn off,
and offer power for the port of higher priority.
• Maximum Power
The Maximum Power value contains a numerical value that indicates the
maximum power in watts that can be delived to a remote device.
Per port maximum value must less than 30.8 watts, total ports values must less
than the Power Reservation value.
Once power overload detected, the port will auto shut down and keep on
detection mode until PD’s power consumption lower than the power limit value.
• Power Allocation
It can limit the port PoE supply watts. Per port maximum value must less than
30.8 watts, total ports values must less than the Power Reservation value.
Once power overload detected, the port will auto shut down and keep on
detection mode until PD’s power consumption lower than the power limit value
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General