EasyManuals Logo

Polycom realpresence group 550 Administrator's Guide

Polycom realpresence group 550
213 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
Administrator’s Guide for the Polycom RealPresence Group Series Security
Polycom, Inc. 116
To enable encryption:
1 Do one of the following:
In the local interface, go to Settings > Administration > Security > Settings.
In the web interface, go to Admin Settings > Security > Global Security > Encryption.
2 Configure these settings.
Configuring Encryption Settings for SVC Calls
You must complete two quick tasks to enable encryption for SVC calls:
Set the transport protocol.
Set AES encryption.
To set the transport protocol:
1 In the web interface, go to Admin Settings > Network > IP Network.
2 Click SIP to expand the section.
3 In the Transport Protocol list, select TLS.
4 Click Save.
To set AES encryption:
1 In the web interface, go to Admin Settings > Security > Global Security.
2 Click Encryption to expand the section.
Setting Description
Require AES Encryption for
Calls
Specifies how to encrypt calls with other sites that support AES encryption.
Off — AES encryption is disabled.
When Available — AES encryption is used in calls with systems that
support it. Calls without encryption are allowed when connecting to
systems that don't support it. For multipoint calls, this means that some
systems might be connected with AES encryption while others are
connected without it.
Required for Video Calls Only — AES encryption is used in all video
calls. Calls with systems that do not support it are disconnected. Audio
calls using an attached SoundStation IP 7000 are allowed to connect.
Required for All Calls — AES encryption is used in all calls. Calls with
systems that do not support it are disconnected. Audio calls using an
attached SoundStation IP 7000 are not allowed to connect, since these
calls are not encrypted.
Require FIPS 140 Cryptography
(web interface only)
Enables the exclusive use of the FIPS 140-2-validated software cryptography
module for cryptographic functions. Also disables all “weak” protocols and
ciphers, including:
SSLv2
SSLv3
Non-FIPS 140-2 approved TLS cipher suites

Table of Contents

Other manuals for Polycom realpresence group 550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom realpresence group 550 and is the answer not in the manual?

Polycom realpresence group 550 Specifications

General IconGeneral
BrandPolycom
Modelrealpresence group 550
CategoryConference System
LanguageEnglish

Related product manuals