Administrator’s Guide for the Polycom RealPresence Group Series Control and Navigation
Polycom, Inc. 136
SmartPairing
SmartPairing allows you to detect and pair a RealPresence Group system from the RealPresence Mobile
application on an Android or Apple iPad tablet. After you pair the application and the RealPresence Group
system, you can use the RealPresence Mobile application to perform two basic functions:
● Use the application as a remote control for the RealPresence Group system.
● Swipe to transfer a call from the RealPresence Mobile application to the RealPresence Group
system.
Be aware that Telnet must be enabled before you can use SmartPairing. Because Telnet is disabled by
default in all Security Profiles, SmartPairing is also disabled by default.The Telnet enable setting is not
configurable when the Security Profile is set to Maximum or High.
To configure SmartPairing:
1 In the web interface, go to Admin Settings > General Settings > Pairing > SmartPairing.
2 Configure these settings.
Configuring Contact Information
You can configure contact information for your Polycom RealPresence Group system so that others know
who to call when they need assistance.
Table: Security Profiles and SmartPairing
Security Profile Telnet Setting Default SmartPairing Available?
Maximum / High Disabled, Not Configurable No
Medium / Low Disabled, Configurable Yes. To use SmartPairing, do the following:
1 Enable Telnet.
2 Send API command or use web interface.
Setting Description
SmartPairing Mode Specifies the method used to pair with the RealPresence Group system, if SmartPairing is
enabled:
• Disabled
•Automatic
•Manual
Signal Volume Specifies the relative signal strength of the ultrasonic signal within the loudspeaker audio
output signal.
Each paired device is displayed in Diagnostics > System > Sessions.