Administrator’s Guide for the Polycom RealPresence Group Series Introducing the RealPresence Group Series
Polycom, Inc. 30
Configuring Menu Settings
The menu settings in the web interface determine some of the information that is displayed in the local
interface’s main menu. The menu settings are pulled from the system’s network settings. For more
information about network settings, refer to Networks on page 31.
To configure local interface menu settings:
1 In the web interface, go to Admin Settings > General Settings > Menu Settings.
2 Configure these settings, then click Save.
Show Extension on the
home screen
Displays the H.323 Extension from Admin Settings > Network > IP Network >
H.323 in the center of the address bar.
Show SIP address on the
home screen
Displays the SIP address from Admin Settings > Network > IP Network > SIP
(the Sign-in Address) on the right side of the address bar.
Note: The Show SIP address setting displays only if your system is configured
with a SIP address.
Setting Description
Show System Information Specifies whether to show certain system information in the local interface menu.
Display Specifies whether to display the following information:
• The system’s SIP Address
• The system’s IP Address
• The Extension associated with the system
Note: The SIP Address setting displays only if your system is configured with a
SIP address.
Show System Button Specifies whether to show a System button in the menu.
Note: The System button in the local interface’s main menu is not the same as the
System link in the blue bar at the top of the web interface page.
Automatic Self View
Control
Specifies whether the Self View setting is visible in the local interface.
• If Automatic Self View Control is enabled, the Self View setting is not in the
local interface, and the system automatically chooses when to display the self
view window. Whether the self view window is displayed is dependent on
available display space, the display mode, and so on.
• If Automatic Self View Control is not enabled, the user can turn Self View on
and off from the local interface.
Setting Description