Polycom realpresence group 550 Administrator's Guide

Administrator’s Guide for the Polycom RealPresence Group Series Microphones and Speakers
Polycom, Inc. 73
When you set up the system for StereoSurround, the left microphone and speaker should be on the left from
the local room perspective. Place the speaker connected to the audio system’s right channel on the right
side of the system, and the other speaker on the left side. The system reverses the left and right channels
for the far site, as shown in the following illustration. This ensures that the sound comes from the appropriate
side of the room.
Figure: StereoSurround Microphone and Speaker Placement
For best results, place the speakers about 60° apart as seen from the center of the conference table.
Figure: Speaker Placement
If you use the subwoofer in the Polycom StereoSurround kit, place it beside a wall or in a corner near the
speakers.
Setting the Speaker Volume
To set the volume of an external speaker system:
1 Do one of the following:
Left
Right
Left
Right
Sending stereo
Receiving stereo
Left
speaker
Connect
to left
audio output
(white)
Right speaker
Connect to
right audio
output (red)

Polycom realpresence group 550 Specifications

General

Brand	Polycom
Model	realpresence group 550
Category	Conference System
Language	English