PREVOST X3-45 Multiplex - Page 139

Section 06: ELECTRICAL
PA1562
3
10.5.2 Removal and Replacement of In-Station Fluorescent Tubes ...............................................45
10.5.3 Removal and Replacement of Reading Lamp Bulb..............................................................45
10.6 ENGINE COMPARTMENT LIGHTING....................................................................................................46
10.7 LAVATORY LIGHT ............................................................................................................................46
11. LIGHT BULB DATA ........................................................................................................................46
12. SPECIFICATIONS...........................................................................................................................49
ILLUSTRATIONS
F
IGURE 1: WIRE IDENTIFICATION .......................................................................................................................5
FIGURE 2: REAR ELECTRICAL JUNCTION PANEL..................................................................................................6
FIGURE 3: MULTIPLEX MODULE CONNECTORS PIN-OUT.......................................................................................7
FIGURE 4: ELECTRICAL COMPARTMENTS (X3-45 COACH) ...................................................................................9
FIGURE 5: REAR ELECTRICAL COMPARTMENT ..................................................................................................10
FIGURE 6: FRONT ELECTRICAL COMPARTMENT ................................................................................................11
FIGURE 7: REAR START PANEL........................................................................................................................11
FIGURE 8: LOCATION OF BATTERIES IN CONDENSER COMPARTMENT..................................................................12
FIGURE 9: BATTERY EQUALIZER......................................................................................................................12
FIGURE 10: ENTRANCE DOOR & WIPER CONTROL PANEL ..................................................................................12
FIGURE 11: BATTERY CONNECTIONS...............................................................................................................14
FIGURE 12: TEST INDICATOR ..........................................................................................................................16
FIGURE 13: LOAD TEST ..................................................................................................................................16
FIGURE 14: ALLIGATOR CLAMPS AND BATTERY ................................................................................................18
FIGURE 15: BOOSTER BLOCK..........................................................................................................................19
FIGURE 16: X3-45 COACHES CAN NETWORK LAYOUT .......................................................................................25
FIGURE 17: IO-B MODULE REMOVAL ................................................................................................................32
FIGURE 18: ALTERNATOR DRIVE BELT .............................................................................................................34
FIGURE 19: TWIN BOSCH ALTERNATORS INSTALLATION (DDEC SERIES 60).........................................................34
FIGURE 20: ALTERNATORS AND ACCESSORIES MOUNTING TORQUES (DDEC SERIES 60).....................................35
FIGURE 21: BOSCH ALTERNATORS MOUNTING TORQUES (VOLVO D13) ..............................................................36
FIGURE 22: TWIN BOSCH ALTERNATORS INSTALLATION (VOLVO D13) ................................................................36
FIGURE 23: ELECTRIC HEATER PLUG LOCATION ...............................................................................................38
FIGURE 24: HEADLIGHT ASSEMBLY .................................................................................................................38
FIGURE 25: OPENING HEADLIGHT ASSEMBLY ...................................................................................................38
FIGURE 26: ALIGNMENT OF HEADLIGHT AIMING SCREEN ...................................................................................39
FIGURE 27: HIGH-INTENSITY ZONE (SHADED AREA) OF A PROPERLY AIMED UPPER BEAM ON THE AIMING SCREEN
7.6 M (25FT) IN FRONT OF VEHICLE..........................................................................................................39
FIGURE 28: HIGH-INTENSITY ZONE (SHADED AREA) OF A PROPERLY AIMED LOWER BEAM ON THE AIMING SCREEN
7.6 M (25FT) IN FRONT OF VEHICLE..........................................................................................................40
FIGURE 29: AIM INSPECTION LIMITS FOR UPPER-BEAM HEADLIGHTS ..................................................................40
FIGURE 30: AIM INSPECTION LIMITS FOR LOWER-BEAM HEADLIGHTS..................................................................40
FIGURE 31: XENON HEADLAMP LOCATION........................................................................................................41
FIGURE 33: SWITCH.......................................................................................................................................43
FIGURE 32: VARIOUS LIGHTS LOCATION...........................................................................................................44
FIGURE 34: PARCEL RACK LIGHTING................................................................................................................46
FIGURE 35: ENGINE COMPARTMENT LIGHT.......................................................................................................46