3
main local global operation trouble-
menu search search shooting
9. Install cover on body, using machine screws, making
certain that the contact plate is in position over fingers
of piston, and arm of contact plate is positioned so that
it will fit in groove of cover.
10. Tighten screws securely. (Torque to 20-30 inch pounds).
TEST OF REBUILT LOW PRESSURE INDICATOR
After rebuilding, perform the leakage and operating tests as
outlined in section Testing for Serviceability.
IMPORTANT! PLEASE READ
When working on or around a vehicle, the following general
precautions should be observed:
1. Park the vehicle on a level surface, apply the parking
brakes, and always block the wheels.
2. Stop the engine when working around the vehicle.
3. If the vehicle is equipped with air brakes, make certain
to drain the air pressure from all reservoirs before
beginning ANY work on the vehicle.
4. Following the vehicle manufacturers recommended
procedures, deactivate the electrical system in a manner
that removes all electrical power from the vehicle.
5. When working in the engine compartment the engine
should be shut off. Where circumstances require that
the engine be in operation, EXTREME CAUTION should
be used to prevent personal injury resulting from contact
with moving, rotating, leaking, heated, or electrically
charged components.
6. Never connect or disconnect a hose or line containing
pressure; it may whip. Never remove a component or
plug unless you are certain all system pressure has
been depleted.
7. Never exceed recommended pressures and always wear
safety glasses.
8. Do not attempt to install, remove, disassemble or
assemble a component until you have read and
thoroughly understand the recommended procedures.
Use only the proper tools and observe all precautions
pertaining to use of those tools.
9. Use only genuine Bendix replacement parts,
components, and kits. Replacement hardware, tubing,
hose, fittings, etc. should be of equivalent size, type,
and strength as original equipment and be designed
specifically for such applications and systems.
10. Components with stripped threads or damaged parts
should be replaced rather than repaired. Repairs requiring
machining or welding should not be attempted unless
specifically approved and stated by the vehicle or
component manufacturer.
11. Prior to returning the vehicle to service, make certain all
components and systems are restored to their proper
operating condition.
BW1447 © AlliedSignal Truck Brake Systems Co. 1/1999. Printed in USA.
To Next Page
Loading...
