EasyManuals Logo

PREVOST X3-45 Multiplex User Manual

PREVOST X3-45 Multiplex
1422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #630 background imageLoading...
Page #630 background image
8
FIGURE 11: M-32
AND M-32QR
MODULATORS DIN SYMBOL
BW2335 © 2004 Bendix Commercial Vehicle Systems LLC 5/2004 Printed in U.S.A. All rights reserved.
Port Designation
Supply 1
Delivery 2
Exhaust 3
Electrical Control
Source 41
Hold 42
Exhaust 43
MODULATOR INSTALLATION
1. Install all air line fittings and plugs, making certain thread
sealing material does not enter the valve.
2. Install the assembled valve on the vehicle.
3. Reconnect both air lines to the valve using the identifi-
cation made during VALVE REMOVAL step 5.
4. Reconnect the electrical connector to the modulator.
5. After installing the valve, test all air fittings for excessive
leakage and tighten as needed.
TECHNICAL INFORMATION
Porting 1 Supply Port (from brake, relay or quick
release valve) - 1/2" NPT
1 Delivery Port (brake actuator) - 1/2" NPT
Optional: 1 Push-to-connect for 1/2" tubing
2 NPT supply, PTC delivery
Solenoid Voltage: 12 Volts DC Nominal, optional
24 Volt available.
Weight: 1.7 pounds
Maximum Operating Pressure: 150 psi Gauge
Operating Temperature Range: -40 to 185
degrees
Fahrenheit
Pressure Differential: 1 psi maximum (supply to delivery)
Mounting Hole Sizes: 0.33" diameter through body

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST X3-45 Multiplex and is the answer not in the manual?

PREVOST X3-45 Multiplex Specifications

General IconGeneral
Length45 ft
Width102 in
EngineVolvo D13
Horsepower500 hp
GVWR54, 000 lbs
Height146 in
Sleeping CapacityVaries based on floor plan
Water CapacityVaries based on floor plan

Related product manuals