165
Chapter 15
Troubleshooting
If you observe a sudden change in the baseline signal you may have excessive humidity
in the vacuum enclosure of the camera. Contact the factory for information on having the
camera vacuum repumped.
Do not attach or remove any cables while the camera system is powered on.
Introduction
The following issues have corresponding troubleshooting sections in this chapter.
Alarm Sounds Sporadically
Alarm Sounds Continuously
Baseline Signal Suddenly Changes
Camera1 (or similar name) on Hardware Setup dialog box
Changing the ST-133 Line Voltage and Fuses
Controller Is Not Responding
Data Loss or Serial Violation
Data Overrun Due to Hardware Conflict message
Data Overrun Has Occurred message
Demo is only Choice on Hardware Wizard:Interface dialog
(Versions 2.5.19.0 and earlier)
Demo, High Speed PCI, and PCI(Timer) are Choices on Hardware
Wizard:Interface dialog (Versions 2.5.19.0 and earlier)
Detector Temperature, Acquire, and Focus are Grayed Out
(Versions 2.5.19.0 and earlier)
Error Creating Controller message
Error Occurs at Computer Powerup
No CCD Named in the Hardware Wizard:CCD dialog
(Versions 2.5.19.0 and earlier)
To Next Page
Loading...
