Appendix C Software 197
Operation of the DG535 Timing Generator becomes available when you select Pulsers
from the Setup menu, next click on the DG535 radio button and then click on the Setup
DG535 button. This opens the DG535 dialog box as shown above. Note that pulser
support must be selected when installing the WinX application software (WinView/32 or
WinSpec/32) for DG535 control to be available, and that the intended use of the DG535
is for operation in conjunction with the PI-MAX CCD Detector.
The DG535 parameters are set via the IEEE-488 GPIB link between the computer and the
DG535 Pulser. The choices provided by the Triggers, Gating and Comm Port tab
pages correspond to those provided by the DG535 front panel, and are described in the
WinX application software Help topics and in the DG535 manual.
To Next Page
Loading...
