Princeton Instruments PI-MAX2 System - Page 28

28 PI-MAX/PI-MAX2 System Manual Version 5.F
Action
Reference
13. Turn the Controller ON.
14. Turn on the computer and begin running the WinX application.
When the computer boots, you may be asked for the location of the
interface drivers. If this is the first time you have used a WinX
application, the Camera Detection wizard will automatically run.
This wizard retrieves information from the camera and/or ST-133
and enters this information as the default parameters for your
system.
Chapter 3 System Setup,
page 38 (PCI drivers),
page 40 (USB drivers),
page 44 (Camera Detection
Wizard)
WinView/32 or
WinSpec/32 manual
15. Verify the hardware setup information or change the parameters, as
appropriate. Enter the pulser information. Enter the experiment setup
parameters. If using a spectrograph, enter that setup information
WinView/32 or
WinSpec/32 manual
Configuring the Software
for Shutter Mode
Operation, page 49
16. Set the target array temperature.
Setting the Temperature,
page 58
17. When the system reaches temperature lock, wait an additional 20
minutes and then begin acquiring data in focus mode.
Initial Data Acquisition,
page 51
18. Adjust the focus for the best image or spectral lines. If you are using
WinSpec/32, you may want to use the Focus Helper function for this
purpose.
Appendix D C-Mount and
F-Mount Adapters,
page 202
Appendix E Spectroscopy-
Mount and Spectrograph
Adapters, page 204