PRÜFTECHNIK ROTALIGN Ultra iS - Laser Safety

ROTALIGN Ultra iS Shaft handbook
12
2.1.3 Laser safety
The ROTALIGN Ultra iS system uses sensALIGN laser ALI 4.910. According to IEC
60825-1, sensALIGN laser is classified as a Class 2 laser product. The laser operates
at 635 nm and has a maximum radiant power <1 mW. It complies with the FDA
specifications 21 CFR 1040.10 and 1040.11 except for deviations pursuant to laser
notice No. 50, dated June 24, 2007. No maintenance is necessary to keep this product
in compliance with the specifications referred to.
 Do not look directly into the laser beam at any time. (The natural blink
reaction of the human eye is normally sufficient to protect the eyes from
any dangers posed by looking at the laser beam briefly. But as natural blink
reaction may fail to occur, care should be taken to avoid staring into the
beam.)
 Do not insert any optical devices into the beam path.
 The red LED on the front of sensALIGN laser illuminates whenever the laser
beam is emitted.
 CAUTION – Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.

WARNING
 Do not look directl
y
into the laser beam at an
y
time. (The natural blink
reaction o
f
the human eye is normally su
ffi
cient to protect the eyes
f
rom
any dangers posed by looking at the laser beam brie
fl
y. But as natural blink
reaction ma
y
fail to occur, care should be taken to avoid starin
g
into the
beam.
)
 Do not insert an
y
optical devices into the beam path.
 Th
e
r
ed
LED
o
n
t
h
e
f
r
o
n
t
of
se
n
s
ALI
G
N l
ase
r ill
u
min
ates
wh
e
n
e
v
e
r
t
h
e
l
ase
r
beam is emitted.
 CAUTION – Use o
f
controls or adjustments or per
f
ormance o
f
procedures
other than those specified herein ma
y
result in hazardous radiation
e
x
pos
u
re.

CAUTION