181
8.1.4 Power management
This section displays the current battery status, allows you to control the power
management features of shutdown, hibernate (sleep mode), and standby. The
following suspend modes are available:
Suspend mode Duration to
standby (Dim)
Duration to
hibernate
(Sleep)
Duration to
shutdown
(Turn off)
Standard – this is the default mode 10 min. 20 min. 0 min.
Full power – the system does not go
to standby or hibernate
0 min. 0 min. 0 min.
Presentation – system goes to
standby after an hour
60 min. 0 min. 60 min.
Long life – system goes to standby
rather quickly
3 min. 5 min. 10 min.
User defined – the standby, hibernate
and shutdown times are user defined
— — —
The recommended suspend modes are standard and
full power.
A user defined suspend
mode is also available. In
this mode, the user may
define the ‘Dim’, ‘Sleep’
and ‘Turn off’ value
boxes are active, and the
standby, hibernate and
shutdown durations as
required.
To set standby and
hibernate modes, press
e while in the “Power
management “ screen
then use
f / g
to highlight required mode
from the drop down menu
that appears. Confirm
selection by pressing
e
or
ß.
In hibernate, power is cut
off completely while in
standby it is not cut off
completely.
Configuration
To Next Page
Loading...
Need help?
General
