PRÜFTECHNIK ROTALIGN Ultra iS User Manual

25
2.5 Handling precautions
ROTALIGN Ultra iS Shaft system and its related components which include ROTALIGN
Ultra iS computer ALI 4.202, sensALIGN sensor ALI 4.900 and sensALIGN laser
ALI 4.910, are precision instruments and should not be dropped or subject to physical
shock.
2.5.1 Storage
Use the ROTALIGN Ultra iS Shaft case ALI 4.820 to transport ROTALIGN Ultra iS Shaft
system and its related components. If the system is not used for an extended period,
remove the related batteries from the components and store the components in a
cool, dry and well-ventilated location.
Observe the storage temperatures and humidity specified in the technical data.
2.5.2 Care
All optical surfaces (sensALIGN laser aperture, sensALIGN sensor lens) must be kept
clean. Use the supplied lens cleaning cloth ALI 2.905. Avoid vigorous polishing to
preserve the anti-reflective coatings of the glass elements. ROTALIGN Ultra iS computer
housing may be wiped clean using a soft cloth dampened with a mild, non-abrasive
detergent (use soapy water with only 1% mild soap in water). The display should be
cleaned using a soft dry cloth.
2.5.3 Maintenance
Although the ROTALIGN Ultra iS Shaft system is essentially maintenance-free, the
following points should be observed:
› The calibration accuracy of the system components should be checked every
two years as indicated by the coloured label (shown at right) affixed to the
bottom of both sensALIGN laser and sensALIGN sensor housings.
› Please return the system components to your authorized PRÜFTECHNIK service
centre for calibration checking by the date indicated.
When returning battery operated ROTALIGN Ultra iS Shaft components to
PRÜFTECHNIK for calibration, service or repair, ensure that the batteries are not
defective. If you suspect a defect in the battery, DO NOT ship the unit with the
defect battery back to PRÜFTECHNIK. You may contact your local representative
for further information.

CAUTION
Observe the stora
g
e temperatures and humidit
y
specified in the technical data.
1
12
11
10
9
8
7
6
5
4
3
2
16
In the example above the
calibration due date is
November 2016

CAUTION
When returnin
g
batter
y
operated ROTALIGN Ultra iS Shaft components to
PR
Ü
FTECHNIK for calibration, service or repair, ensure that the batteries are not
de
f
ective. I
f
you suspect a de
f
ect in the battery, DO NOT ship the unit with the
defect battery back to PR
Ü
FTECHNIK. You may contact your local representative
fo
r
fu
r
t
h
e
r in
fo
rm
at
i
o
n.
Handling precautions

PRÜFTECHNIK ROTALIGN Ultra iS Specifications

General

Brand	PRÜFTECHNIK
Model	ROTALIGN Ultra iS
Category	Laser Shaft Alignment Tools
Language	English