PRÜFTECHNIK ROTALIGN Ultra iS - Chapter 4: Shaft Alignment Application; 4.1 Starting the Shaft Alignment Application

ROTALIGN Ultra iS Shaft handbook
34
3.3.4 Measurement
 Pressing
m twice activates auto measurement.
In auto measurement any of the three measurement modes – IntelliSWEEP,
Multipoint or Static measurement is started directly by the appropriate action.
 IntelliSWEEP mode is activated by rotating the shafts
 Multipoint is started by pressing
e
 Static measurement is started by pressing either the data entry keys or any
of the navigation keys
3.3.5 Results
 Pressing
f or g while in results, cycles the results between vertical (V),
horizontal (H) and both H&V.
 Pressing
f or g long enough zooms out or zooms in the results image
respectively.
In auto measurement any of the three measurement modes – IntelliSWEEP,
Mu
l
tipoint or Static measurement is starte
d
d
irect
l
y
b
y t
h
e appropriate action.
 IntelliSWEEP mode is activated by rotating the shafts
 Multipoint is started b
y
pressin
g
e

Static measurement is starte
d
b
y pressing eit
h
er t
h
e
d
ata entry
k
eys or any
of the navi
g
ation ke
y
s

Note