PRÜFTECHNIK ROTALIGN Ultra iS - Positioning Laser and Mounting Sensor for Measurement

151
6.2.5 Positioning laser and mounting sensor for measurement
In this step, the laser is remounted on the underside of the laser holder while the
sensor is mounted on the shaft of the machine to be aligned.
1. Switch off the laser and remove it from its holder.
2. Using the provided M4 Allen key, loosen the support posts then slide them
through the laser holder base so that they protrude from the other side.
3. Retighten the M4 Allen screws to secure the support posts, then remount the
laser onto the support posts.
4. Use the chain-type bracket or appropriate magnetic brackets to mount the
sensor on the shaft of the machine to be moved (for instance the motor or
gearbox). The sensor is aligned to the laser by pushing or sliding the bracket
supporting the sensor.
Do not touch the laser or its laser position thumbwheels.
Note
Do not touc
h
t
h
e
l
aser or its
l
aser position t
h
um
b
w
h
ee
l
s.
Cardan drives