PRÜFTECHNIK ROTALIGN Ultra iS User Manual

ROTALIGN Ultra iS Shaft handbook
82
4.16 Alignment completion
After completion of an alignment measurement or job, press
e and hold down for
a moment to switch ROTALIGN Ultra iS computer off. Alternatively one may use the
global menu combination ‘Quit’/’Turn off device’. If the measurement file has not
been saved, the following query appears:
 ‘Do you really want to turn off the system?’
Selecting ‘Yes’ to turn off the system prompts the following question:
 ‘Do you want to save changes in file?’
Save file if required for record and analysis. If it is not required, selecting ‘No’ turns
off the system.
 Switch both sensALIGN laser and sensor off and slide back both laser and sensor
dust caps to cover the apertures.
Remove the components from the shafts and store them in the case.
Replace guards before you switch the machine back on.

WARNING
Remove the com
p
onents from the shafts and store them in the case.
Replace guards be
f
ore you switch the machine back on.

PRÜFTECHNIK ROTALIGN Ultra iS Specifications

General

Brand	PRÜFTECHNIK
Model	ROTALIGN Ultra iS
Category	Laser Shaft Alignment Tools
Language	English