ROTALIGN Ultra iS Shaft handbook
200
8.4 Deleting created templates from the program manager
Press
q twice to open the global menu while in the Shaft Alignment application.
Confirm selection by pressing
e. The “Template list” screen opens. Use f/g
to highlight the template to be deleted, then press
q to open the screen context
menu.
With the context menu displayed, use
f/g to
highlight the item ‘Delete’. Confirm by pressing
e.
A message pops up requesting confirmation if the file should actually be deleted.
Use
i/h to highlight ‘Yes’ and confirm selection by pressing
e. The template is
deleted from the templates list.
Alternatively, templates may be opened via the global menu items ‘File’->’Open’,
followed by the “Open document” screen context menu items ‘Template’/’Template’.
If you select a template
and set it as the ‘default’
template, a working file
based on this template
will be started every time
you launch the Shaft
Alignment application. If
you do not designate a
default template, a working
file based on the factory
default template will launch
instead.
To Next Page
Loading...
