ROTALIGN Ultra iS Shaft handbook
56
4.12 Taking measurements
With all four sensALIGN laser beam adjustment LED blinking green once every
second – an indication that the laser beam has been correctly adjusted – press
m to
open the measurement screen. As sensALIGN sensor has not yet been initialized, the
‘Sensor error’ message will appear on the screen. Press
q then use f/g to
highlight the context menu item ‘Sensor selection.
Confirm selection by pressing
e. The sensor selection window opens.
Use
f/g to highlight ‘Scan for wireless devices’, then press e to confirm
selection. With this step, the neighbourhood is scanned for Bluetooth devices.
The sensor selection
window may also be used
to select the sensALIGN
sensor and laser cable ALI
4.921-2 to transmit data
between ROTALIGN Ultra iS
computer and sensALIGN
sensor. This emergency
alternative is described in
section 4.12a.
To Next Page
Loading...
