PRÜFTECHNIK ROTALIGN Ultra iS - 4.2 Preparing for Horizontal Machine Alignment

35
Chapter 4: Shaft alignment application
4.1 Starting the shaft alignment application
Before the application can be started, a licence code must be entered in the
licence manager. In most cases the application is licenced at the factory and
the system is delivered with the Advanced Shaft firmware registration certificate
ALI 4.741 which contains the entered licence code.
4.1.1 Starting the licence manager
After switching ROTALIGN Ultra on, use the navigation keys to highlight ‘Configuration’
icon.
Press
e to access this option, then use the navigation keys to highlight the ‘Licence
Manager’ icon.
Note
B
efore the application can be started, a licence code must be entered in the
licence mana
g
er. In most cases the application is licenced at the factor
y
and
the s
y
stem is delivered with the
A
dvanced Shaft firmware re
g
istration certificate
ALI 4.741 w
h
ic
h
contains t
h
e entere
d
l
icence co
d
e
.
Starting the application