PRÜFTECHNIK ROTALIGN Ultra iS - Adjusting the Laser Beam to Machine’s Rotational Axis

ROTALIGN
®
Ultra iS Shaft handbook
150
As soon as a single dot position has been achieved, do not touch the laser
position thumbwheels.
6.2.4. Adjusting the laser beam to machine’s rotational axis
In this step, the laser holder assembly is adjusted on the bracket such that the laser
holder rotational axis is colinear with the rotational axis of machine to be aligned
(which could be a motor or a gearbox).
During this procedure, DO NOT touch the yellow laser beam position
thumbwheels.
1. Carry out the vertical and horizontal adjustment of the laser holder assembly
by sliding it horizontally through the bracket rail and positioning it vertically by
rotating the bracket.
2. Repeat the above procedure until the laser beam strikes the center of the target
placed on the rotational axis of machine to be aligned.
3. Once the laser beam has been centered on the target, tighten the faceplate on
the coupling face using the provided hexagon socket head screws.
Note
Durin
g
this procedure, DO NOT touch the
y
ellow laser beam position
t
h
um
b
w
h
ee
l
s
.
Laser dot
3c