Getting started
33
Pressing either o or p moves the view of the train to the right or left
respectively.
3.3.3 Dimensions (set-up)
When in set-up and units are set to Imperial system, entering a dimension as
11.3.8 corresponds to 11 3/8 in.
Pressing
c while in set-up prompts the deletion of the selected machine.
When selecting type of machine the orientation of the machine can be altered
by pressing either
h or i.
Pressing
d twice while in set-up zooms the machine train out and in again.
When entering file or element names, pressing
o cycles through the characters
that can be entered. The characters are capital letters (upper case), small letters
(lower case) and numerals. With numerals selected, pressing
1 long enough
enters the value π.
Pressing
f or g zooms out or zooms in the machine image respectively.
Note that any one of the train elements has to be highlighted for the zoom
function to respond.
To Next Page
Loading...
Need help?
General
