Appendix D: Radio Parameters
TRX7431 WaveLAN/IEEE 802.11 DS SS Radios
D-2
Teklogix 7035, 8255 & 8260 Terminals User Manual
Station
The value entered in this parameter, to a maximum of 32 characters, is used to
identify the terminal (an 802.11 station) for diagnostic purposes.
AP Density
This parameter determines the density of access points in a network. The density
can be set to one of the following: Low, Medium or High.
Data Rate
The value entered in this parameter specifies the data rate to be used for message
transmission. The data rate can be set to one of the following: 1Mbit, 2Mbit,
5.5Mbit or 11Mbit.
Note: Keep in mind that an Access Point or 7035 can only communicate at 11
Mbit if “Data Rate” is set to “Auto”.
Reservation
“Reservation” specifies the medium reservation setting to be used. The medium
reservation specifies the number of octets in a message or fragment above which
a RTS/CTS handshake is performed to reserve the medium for the message or
fragment transmission. Setting this parameter to the maximum allowable value,
2347, disables medium reservation.
Pwr Saving
When this parameter is enabled (set to “Y”), the radio operates in power saving
mode, utilizing the parameters listed in this sub-menu.
Rx Multicasts
When this parameter is set to “Y”, the terminal wakes from a sleep or suspend state
each time a multicast – a broadcast sent to multiple recipients from a single packet –
is sent over the network. “Rx Multicast” should be left disabled (set to “N”).
RX Multicasts N Y/N
Sleep Duration 100 1-65535
Range
Pwr Saving
To Next Page
Loading...