Teklogix 7035, 8255 & 8260 Terminals User Manual D-3
Appendix D: Radio Parameters
TRX7431 WaveLAN/IEEE 802.11 DS SS Radios
Sleep Duration
The value assigned for this parameter determines how many milliseconds must pass
before the terminal enters a full power state from a suspend state in order to check
for messages. If there are no messages, the terminal returns to suspend state.
Important: If the value assigned to this parameter is set at too high, you risk
missing messages sent over the network.
Network
The value assigned for this parameter – Infra or Adhoc – configures the radio to
operate in either an Ad Hoc (“Adhoc”) or Infrastructure (“Infra”) network. In an Ad
Hoc network, terminals pass data directly to other terminals – an access point is not
required. In an Infrastructure network, terminals must pass data through an access
point – terminals cannot communicate directly with other terminals in the network.
Channel
Important: The “Channel” parameter takes effect only when the “Network”
parameter is set to
Adhoc.
The channel number you choose must be the same for all terminals on the network
that are set to
Adhoc.
WEP Encrypt (Wired-Equivalent Privacy)
Note: This parameter is designed for use with Lucent WaveLAN 802 Silver
and Gold PC cards only. If another type of WaveLAN PC card is installed
in your terminal, “WEP Encrypt” must be disabled (set to “N”).
If the PC card installed in your terminal is not a WaveLAN card,
“WEP Encrypt” will not appear in the Radio menu.
Key 1 12345
Key 2
Key 3
Key 4
Tx Key 1
WEP Encrypt
To Next Page
Loading...