Ricoh D117 - Page 380

SC Tables
SM 6-19 D117/D118
Troubleshooti
ng
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
1. Remove the heat seal from each PCDU.
2. Replace the defective PCDU.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
396 D Drum/Development motor error: Bk
397 D Drum/Development motor error: Cy, Ma, Ye
- -
The machine detects a High signal from the drum/development motor
for 2 seconds after the drum/development motor turned on.
 Overload on the drum/development motor
 Defective drum/development motor
 Defective harness
 Shorted 24 V fuse on the PSU
 Defective interlock system
1. Check or replace the harness.
2. Replace the drum/development motor.
3. Replace the 24V fuse on the PSU.