Ricoh P C301W - Page 161

5.System Maintenance
149
Menu
Description
the EEPROM on the EGB.
Init. LSU data
Resets the LD driver parameters
written to the EEPROM on the
EGB.
Trans. Belt Adjustment
Executes the transfer belt
adjustment. This calibrates the
motor speed to match the length of
the new transfer belt.
Color Registration
Executes the color registration and
density tuning automatically.
Reset Transfer Unit
Resets the image transfer unit life
counter.
Reset Fuser Unit
Resets the fusing unit life counter.
Reset 2nd Transfer unit
Resets the paper transfer unit
(transfer roller) life counter.
Fuser SC
Detect
Fusing JAM Detection
Determines whether or not the SC
code is issued after three
successive jams in the fusing unit.
[0 (OFF) / 1(ON)]
SC Number
Displays the SC number occurred.
Temp.occurred
Heat Center
Displays the temperature (°C) at
the fusing thermopile when the
fusing related SC occurred.
Heat NC
Displays the temperature (°C) at
the fusing NC sensor when fusing
related SC occurred.
Press Center
Displays the temperature (°C) at
the pressure roller thermistor
(center) when fusing related SC
occurred.
Press Left
Displays the temperature (°C) at
the pressure thermistor (end) when
fusing related SC occurred.
Press Right
(Reserved)
Temp.before 1cycle
Heat Center
Displays the temperature (°C) of
each sensor at the occurrence of
the 1st fusing SC code before the
Heat NC
Press Center