Rohde & Schwarz ESW Series - Page 563

Remote Commands in the Receiver Application
R&S
®
ESW
563User Manual 1177.6298.02 ─ 08
<dl> 1 | 2
time line
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:TLIN:STAT ON
Turns the first time line on.
15.7.5.2
Limit Lines
● Limit Line Management.........................................................................................563
● Limit Line Design...................................................................................................568
● Limit Check........................................................................................................... 575
● Programming Example: Using Limit Lines............................................................ 576
Limit Line Management
CALCulate<n>:LIMit<li>:ACTive?.....................................................................................563
CALCulate<n>:LIMit<li>:CONTrol:OFFSet........................................................................ 564
CALCulate<n>:LIMit<li>:COPY........................................................................................564
CALCulate<n>:LIMit<li>:DELete...................................................................................... 564
CALCulate<n>:LIMit<li>:LOWer:OFFSet...........................................................................565
CALCulate<n>:LIMit<li>:LOWer:STATe.............................................................................565
CALCulate<n>:LIMit<li>:STATe........................................................................................565
CALCulate<n>:LIMit<li>:TRACe<t>..................................................................................566
CALCulate<n>:LIMit<li>:TRACe<t>:CHECk......................................................................566
CALCulate<n>:LIMit<li>:UPPer:OFFSet........................................................................... 567
CALCulate<n>:LIMit<li>:UPPer:STATe............................................................................. 567
MMEMory:LOAD<n>:LIMit.............................................................................................. 567
MMEMory:STORe<n>:LIMit............................................................................................ 568
CALCulate<n>:LIMit<li>:ACTive?
This command queries the names of all active limit lines.
Suffix:
<n>
.
irrelevant
<li> irrelevant
Return values:
<LimitLines> String containing the names of all active limit lines in alphabeti-
cal order.
Example:
CALC:LIM:ACT?
Queries the names of all active limit lines.
Usage: Query only
Analysis