Rohde & Schwarz SMAB-B92 - Page 462

Remote Control Commands
R&S
®
SMA100B
460User Manual 1178.3834.02 ─ 05
:SENSe<ch>[:POWer]:SWEep:POWer[:SENSor]:SFRequency <SFRequency>
Defines the separate frequency used for power vs. power measurement.
Parameters:
<SFRequency> float
Range: 0 to 1E12
Increment: 1
*RST: 1E6
Example:
SENS1:SWE:POW:SENS:SFR 2GHz
The measurement is performed at 2 GHz
Manual operation: See " Use Separate Frequency- Power Analysis " on page 240
:SENSe<ch>[:POWer]:SWEep:POWer[:SENSor]:SFRequency:STATe
<State>
Activates the use of a different frequency for the power measurement.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SENS1:SWE:POW:SENS:SFR:STAT ON
Activates the use of a separate frequency than the generator fre-
quency for power analysis
Manual operation: See " Use Separate Frequency- Power Analysis " on page 240
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:OFFSet <Offset>
Defines the level offset at the sensor input in dB. Activate the offset with the com-
mand :SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:OFFSet:STATe
on page 461.
Parameters:
<Offset> float
Range: -100 to 100
Increment: 0.01
*RST: 0
Example:
SENS2:SWE:TIME:OFFS -7dB
Defines a level offset of -7 dB.
SENS2:SWE:TIME:OFFS:STAT ON
The specified level offset is considered.
Options: Option R&S SMAB-K28
Manual operation: See " Level Offset - Power Analysis " on page 240
Power Sensor Measurement Subsystems