Remote Control Commands
R&S
®
SMA100B
461User Manual 1178.3834.02 ─ 05
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:OFFSet:STATe <State>
Activates a level offset at the sensor input. Define the appropriate value with the com-
mand :SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:OFFSet on page 460.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SENS2:SWE:POW:TIME:STAT ON
Activates the specified level offset.
Options: Option R&S SMAB-K28
Manual operation: See " Level Offset State- Power Analysis " on page 239
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:PULSe:STATe
<State>
Enables pulse data analysis. The measurement is started with command INITiate.
Note: The command is only available in time measurement mode and with R&S NRP-
Z81 power sensors.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SENS1:SWE:TIM:PULS:STAT ON
Enables pulse data analysis.
Options: Option R&S SMAB-K28
Manual operation: See " State - Pulse Data Analysis " on page 243
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:PULSe:THReshold:BASE <Base>
Selects how the threshold parameters for pulse analysis are calculated.
Note: The command is only available in time measurement mode and with R&S
NRPZ81 power sensors.
Parameters:
<Base> VOLTage | POWer
*RST: VOLTage
Example:
SENS1:SWE:TIME:PULS:THR:BASE POW
Activates threshold calculation related to power.
Options: Option R&S SMAB-K28
Manual operation: See " Base - Pulse Data Analysis " on page 243
Power Sensor Measurement Subsystems
To Next Page
Loading...
